440 VOLT WINNER INVERTER,S MOTOR PROTECTION TABLE

No
Name
                                                   Description
Setting range
Factory setting
Change during operation
Control methods
v/f
v/f with pg
Open loop vector
Flux vector
L1-01
Motor protection selection
Sets whether the motor overload function is enabled or disabled at electric thermal overload relay
0: disabled
1:enabled
Note : this setting enables or disables the motor overload protection function. The rated current setting (e2 – 01 ) is used as a basis for overload detection . when several motors are connected to one inverter set to 0 (disabled) and ensure that each motor is installed with a protection .
Device . in some applications when the inverter power supply is turned off , the thermal value is reset so even if this constant is set to 1, (enabled) . protection may not be effective . if the overload ol1 alarm (1f)is set in one of the multi function outputs (h2-01 to h2-03) , the output will be turned on when the electronic thermal value reaches 90% of the overload detection level .
0,1
1
x
B
B
B
B
L1-02
Motor protection time constant
The detection time of electronic thermal protection it is in undo of minute
Note : normally it is not necessary to change this setting . (the factory setting is a 150% 1 minute capacity ) . set the electronic thermal protection operation time if a 150% overload is applied after operating continuously at the motor ,s rated current (hot start) . when the motor ,s overload capacity level is known , set the hot start overload resistance level for the motor , but be sure to allow some margin for safety . decrease this setting when you want to detect an overload more quickly .
0.1~5.0
1.0
x
B
B
B
B
L2-01
Motor protection time constant
This constant specifies the processing that is performed when a momentary power loss occurs .
0 : disabled (an under voltage fault is detected when there is a momentary power loss ) .
1 : enabled ( restarts if power is restored within the l2-02 time . an under voltage fault is detected for a longer power loss ).
2 : enabled during cpu operation ( restarts if power is restored while the cpu is operating  an under voltage fault is not detected ).
Note :when power loss ride thru is enabled ( setting 1 or 2) operation will be restarted after a speed search if the power is restored within the allowed time interval when power loss ride thru is disabled ( setting 0) an under voltage fault will be detected if power is interrupted , for more than 15 ms
0~2
0
X
B
B
B
B

 

 



 

3 thoughts on “440 volt inverter motor protection table”
  1. Hello! I could have sworn I’ve been to this blog before but after browsing through some of the post I realized it’s new to me. Anyways, I’m definitely happy I found it and I’ll be book-marking and checking back frequently!

  2. We are a bunch of volunteers and starting a brand new scheme in our community. Your website provided us with useful information to work on. You’ve performed an impressive activity and our whole community shall be thankful to you.

Leave a Reply

Your email address will not be published. Required fields are marked *