ENERGY SAVING

ENERGY SAVING this is the frequency lower limit within the effective range of energy saving control . it is set in unit of Hz . please set the frequency lower limit within the effective range of energy saving control. energy saving command . it starts only from the frequency which is above the lowest energy … Read more

torque converter

TORQUE CONVERTER / INVERTER. use for control starting load when this function is used the start torque converter compensation is set by command mechanical friction load , for the elevator.the setting of torque converter start torque rising time is in unit of Mr s(note )filter delay is disabled when the setting is between 0~4 ms NOTE: … Read more

frequency speed and voltage of inverter

  set only  to fine adjust v/f for the output range when using flux vector control of frequency speed and voltage of inverter .normally this setting range and factory setting will be cut by 50%  for the inverter of 200v class . to set the constant e 1-0 4 ~e 1-10 when e 1-0 3 =”f” … Read more

motor system

motor system in inverter MOTOR 2 LINE TO LINE RESISTANCE . To set the motor,s line to line resistance in unit of ohm . note: the factory setting depends on the capacity of the inverter . please set the motor,s line to line resistance u v v – w w u  normally you need to … Read more

inverter speed value

inverter speed value . Enable /disable integral value during ace/decal , 0: disable (the integral function is not used while accelerating or decelerating : it is used at constant speed). 1: enabled (the integral function is used at all times), note: when v/f control with pg feedback is used integral control during acceleration and deceleration … Read more

digital systems

DIGITAL SYSTEMS INPUT OPTION OF INVERTER. To set the input method of digital command card . 0: bcd . 1% 1: bcdo . 1% 2: bcdo. 01% unit 3: bcd 1Hz unit. 4:bcdo . 1 Hz unit 5:bcdo. 1Hz unit . 6: bcd special setting (5-digital input) . 7: binary system. note: when using a … Read more

working of inverter

FUNCTION TABLE OF MULTI FUNCTION  INPUT (H1). 0: 3 line system program control (forward / reverse command ). 1: local / remote selection (on operator off parameter setting). 2: selection / inverter selection (on is optional ). 3: when h3 – 05 ( multi functional multi speed command 1 analog input function selection ) is … Read more

inverter panel

PANEL/REMOTE SETTING VALUE 1. OFF:To select frequency command (b1-01) and operation command (b1-02). ON : Set frequency command/operation command by digital operator . To switch the input method between frequency command and operation command . To switch only at the stop of inverter . Once  the function was set digital keyboard operation method selection key … Read more

HOW TO SETTING 440 VOLT INVERTER,S

SETTING OF INVERTERS. No Name                                 Description Setting range Factory setting Change during operation Control methods v/f v/f with pg Open loop vector Flux vector L2-02 Momentary power loss ride thru time This setting is valid only when constant l 2-01 is set to 1. Set the power loss ride thru time in seconds. Note … Read more