PANEL/REMOTE SETTING VALUE 1.
OFF:To select frequency command (b1-01) and operation command (b1-02).
ON : Set frequency command/operation command by digital operator .
To switch the input method between frequency command and operation command .
To switch only at the stop of inverter .
Once the function was set digital keyboard operation method selection key (local /remote) will be non effective .
OPTION CARD/INVERTER SELECTION SETTING 2.
OFF:Inverter,s frequency command is enabled .
ON: Frequency command of selection card is enabled .
Among the frequency command input from inverter or option card ,whichever is effective can be switched .but it is can be switched only at the inverter,s stop . please set frequency option (b1-01) to be 0 (keyboard ) or 1 (analog input of exterior terminal) . when it is set as 3 (option card) , only option card,s frequency command is effective . in the occasion where a1-14b card is used and f2-01 (operation selection of analog command card) is 0 (3 ch inputs respectively ), you can not see option card / inverter selection . when a1-14b , d1-16 h 2 or other card does not match the operation command, only the frequency command can be changed while the operation command can not be changed .
BASE ELECTRODE LOCKING COMMAND NO VALUE 8 .
OFF:Normal operation.
On : on base locking .
3 line system program for/rev command (setting, 0). when any one of multi function input terminal will be for/rev command terminal. in the 3 (terminal 5) will become the input terminal of for/rev command .
Terrific post however I was wanting to know if you could write a litte more on this topic? I’d be very thankful if you could elaborate a little bit further. Cheers!
Woah! I’m really digging the template/theme of this site. It’s simple, yet effective. A lot of times it’s very difficult to get that “perfect balance” between usability and visual appearance. I must say that you’ve done a awesome job with this. Also, the blog loads extremely fast for me on Opera. Outstanding Blog!