OPERATION SELECTION AT OVER SPEED/ DEVIATION . winner inverter set the stop method when over speed occurs.0:deceleration to stop using deceleration time 1 (c 1-0 2). 1: coast to stop. 2: emergency stops using the emergency stop time ( c 1-0 9). 3:continue operation it dose not need to be set normally to protect the … Read more
inverter speed value . Enable /disable integral value during ace/decal , 0: disable (the integral function is not used while accelerating or decelerating : it is used at constant speed). 1: enabled (the integral function is used at all times), note: when v/f control with pg feedback is used integral control during acceleration and deceleration … Read more
DIGITAL SYSTEMS INPUT OPTION OF INVERTER. To set the input method of digital command card . 0: bcd . 1% 1: bcdo . 1% 2: bcdo. 01% unit 3: bcd 1Hz unit. 4:bcdo . 1 Hz unit 5:bcdo. 1Hz unit . 6: bcd special setting (5-digital input) . 7: binary system. note: when using a … Read more
3 PHASE INVERTER OUTPUT MODE SELECTION . Set the 3 phase inverter output mode in the following constants when using a d0-08 digital output card 0: – channel individual outputs code output ( binary system code) . note: the item output by d0-08 according to f6-01 setting , please set the code output as follows. … Read more
TO CANCEL PID CONTROL off = pid control is enabled . on = pid control is disabled ( normal control of inverter ) with this setting ,the multi – function input switches between pid control and normal inverter control . this function can be used to perform trial operation or jog operation with normal inverter … Read more
EXTERIOR FAULT ,(SETTING,20-2 F) This is to set how to output the warning to exterior when the exterior equipment is at fault or in a abnormal status and the inverter stops. as the input condition for exterior fault , it can choose the inverter,s action when the exterior is input . the following setting … Read more
SOLAR MAX INVERTER,S SPECIFICATIONS model 1.2K 2.4K Input voltage 230 VAC Voltage range 170-280 VAC(narrow mode) 90-280vac(wide mode) OUTPUT Voltage regulation (BATT.MODE) +/-10% Transfer time 20 ms typical Wave form Simulated since wave BATTERY Battery voltage 12vdc 24vdc Floating charge voltage 13.5vdc+_0.5 VDC 27.0vdc+_0.5vdc Maximum … Read more
Terminal s/n Content Specification Ta 1 1 Power supply for encoder Dc + 12v (+-5)max .20ma 2 Dc o v ( grounding terminal for power supply) 3 A phase pulse input terminal H : +8v ~12v L:>+ 1v (max, response frequency 30 Hz) 4 A phase pulse input terminal 5 B phase input terminal … Read more
NOTE : Before installation please inspect the unit be sure that nothing inside the package is damaged. Installation note before installation,please inspect the unit. be sure that nothing inside the package is damaged. Mountain the unit The unit only can be mounted vertically to a wall surface. please follow below steps: 1. Turn off the … Read more
Signal level selection of multi function analogy terminal 14 0: 0~+ 10 volt please make sure to cut off the over line 1 1: 0 ~+_10 volt please make sure to cut off the over line 1 2: 4 ~ +_20 ma ( 10 bit input ) frequency (current ) it is effective when b1 _ … Read more