inverter setting values. 440 volt inverter OUTPUT VOLTAGE LIMIT OPTIONS OF 440 VOLT INVERTER. 0: DISABLED. 1:EFFECTIVE THE MOTORS FLUX FALLS AUTOMATICALLY WHEN THE OUTPUT VOLTAGES REACHES SATURATION STATUS. INVERTER/MOTOR CURRENT. NOTE: OUTPUT VOLTAGE LIMIT ACTION IS DISABLED , IF THE OUTPUT VOLTAGE REACHES SATURATION STATUS, THE OUTPUT CURRENT HAS NO CHANGE BUT THE TORQUE … Read more
electric inverter frequency reference when the multi function inputs jog frequency reference selection f jog command and r jog command are on.the electric inverter frequency reference default value and set value will change when 0 1-0 3 is changed, for example if preset reference 1 is set to 6.00 Hz and 01-03 is changed to … Read more
TORQUE REFERENCE DELAY TIME . the primary delay time constant of torque command filter is set in unit of m r s to adjust the electric inverter torque reference time constant of the primary delay filmier . to adjust the noise of the torque control signal or the responsive nests with the host controller … Read more
motor system in inverter MOTOR 2 LINE TO LINE RESISTANCE . To set the motor,s line to line resistance in unit of ohm . note: the factory setting depends on the capacity of the inverter . please set the motor,s line to line resistance u v v – w w u normally you need to … Read more
OPERATION SELECTION AT OVER SPEED/ DEVIATION . winner inverter set the stop method when over speed occurs.0:deceleration to stop using deceleration time 1 (c 1-0 2). 1: coast to stop. 2: emergency stops using the emergency stop time ( c 1-0 9). 3:continue operation it dose not need to be set normally to protect the … Read more
inverter speed value . Enable /disable integral value during ace/decal , 0: disable (the integral function is not used while accelerating or decelerating : it is used at constant speed). 1: enabled (the integral function is used at all times), note: when v/f control with pg feedback is used integral control during acceleration and deceleration … Read more
3 PHASE INVERTER OUTPUT MODE SELECTION . Set the 3 phase inverter output mode in the following constants when using a d0-08 digital output card 0: – channel individual outputs code output ( binary system code) . note: the item output by d0-08 according to f6-01 setting , please set the code output as follows. … Read more