OPERATION SELECTION AT OVER SPEED/ DEVIATION . winner inverter set the stop method when over speed occurs.0:deceleration to stop using deceleration time 1 (c 1-0 2). 1: coast to stop. 2: emergency stops using the emergency stop time ( c 1-0 9). 3:continue operation it dose not need to be set normally to protect the … Read more
inverter speed value . Enable /disable integral value during ace/decal , 0: disable (the integral function is not used while accelerating or decelerating : it is used at constant speed). 1: enabled (the integral function is used at all times), note: when v/f control with pg feedback is used integral control during acceleration and deceleration … Read more
3 PHASE INVERTER OUTPUT MODE SELECTION . Set the 3 phase inverter output mode in the following constants when using a d0-08 digital output card 0: – channel individual outputs code output ( binary system code) . note: the item output by d0-08 according to f6-01 setting , please set the code output as follows. … Read more
forward torque limit set the torque limit values as a percentage of the motor rated torque.four indevidual regions can be set. reverse torque limit note: torque limits can be set seperately for the 4 ways that torque can be applied: forward torque,reverse torque,forwards generative torque,and reverse generative torque. forward regenerative torque limit show the relationship … Read more
monitor selection after power up when the inverter is started please set the item need to display 1: frequency command 2: frequency command. 3: output current 4:the displayed item set by 01 _ o1. when inverter is started, the display the frequency command in the data displaying part (when factory setting is available) when the … Read more
