winner inverter

by
Signal level selection of multi function analogy terminal  14
0: 0~+ 10 volt please make sure to cut off the over line 1
1: 0 ~+_10 volt please make sure to cut off the over line 1
2: 4 ~ +_20 ma  ( 10 bit input )
frequency (current ) it is effective when b1 _ 01 (frequency command selection ) is set to be 1
signal level to set frequency command (current )signal .
Note of setting
Setting value
content
0
0~+10v input  (10 bit input )
1
0~+_10v input (when the voltage is minus ,it will be the operation command which has opposite operation to the operation of the given command )
2
4~20ma input
When used as input voltage terminal ( setting : 0 or  1 , please cut off the over line on the control plate  ( if not the resistor will be burned ) . when voltage input terminal and current input terminal input frequency command simultaneously their summation will be the ultimate command value , in the occasion where voltage terminal and current terminal are used in turn , please set one of the multi function input ( H1_01 ~06 ) to be 1f and this multi function input 1S in off status , the current terminal (14) ,s command will be effective as long as the command from the voltage terminal ( 13 ) is on  , when it is Et as 1 ( 0~ +_ 10 volt  input ) it is necessary that H3_01 is 1 too (0~+_ 10 volt input )

Setting value
function
The content of each function at 100% input
Control methods
v/f
v/f
with pg
Open loop vector
Flux vector
0
H3 – 05 , auxiliary frequency command
Max , output frequency
0
0
0
0
H3 – 09 , it cannot be set to be ,0,
1
Frequency gain
The value of frequency command ( voltage)
0
0
0
0
2
Frequency off set  (zero limit when operation direction changes )
Maximum output frequency (added to h3 – 03 )
0
0
0
0
4
Output voltage off set
Motor rated voltage (E1-05)
0
0
x
x
5
Time gain of acceleration/ deceleration (reduction ratio)
The set acceleration time (C1- o1~o8)
0
0
0
0
6
DC braking (DB)current
Inverter rated current
0
0
0
x
7
Over torque detection level
Motor rated torque
0
0
0
0
8
Stall prevention level in operation
Inverter rated current
0
0
x
x
9
Output frequency lower limit level
Max output frequency
0
0
0
0
A
Prohibited frequency setting
Max output frequency
0
0
0
0
B
PID feed back
Max output frequency
0
0
0
0
C
PID target value
Max output frequency
0
0
0
0
D
Frequency off set
Note: it is cannot be set simultaneously (opeo7)
Max output frequency (plus H3 – o3)
0
0
0
0
10
Forward side torque limit
Motor rated torque
x
x
0
0
11
Reverse operation side torque limit
Motor rated torque
x
x
0
0
12
Torque limit in regeneration status
Motor rated torque
x
x
0
0
13
Torque command/torque limit when speed controls
Motor rated torque
x
x
x
0
14
Torque compensation
Motor rated torque
x
x
x
0
15
For / rev two sides torque limit
Motor rated torque
x
x
x
0
1f
H3 – 05 , analog input will not be used
Max output frequency
0
0
0
0
Frequency command (please find function chart for details )

 

1 thought on “winner inverter”

Leave a Comment