electric inverter carrier frequency
CARRIER FREQUENCY set the upper limit and lower limit in K Hz units . the carrier frequency gain is set as follows . frequency is fixed parameters at electric inverter…
electric inverter afr gain and frequency
ELECTRIC INVERTER carrier frequency is 2 k Hz . 1:carrier frequency is the setting of c 6-0 1. 2: carrier frequency is 5 k Hz electric inverter carrier frequency of…
electric inverter frequency
electric inverter frequency reference when the multi function inputs jog frequency reference selection f jog command and r jog command are on.the electric inverter frequency reference default value and set…
electric inverter torque reference
TORQUE REFERENCE DELAY TIME . the primary delay time constant of torque command filter is set in unit of m r s to adjust the electric inverter torque reference time…
frequency speed and voltage of inverter
set only to fine adjust v/f for the output range when using flux vector control of frequency speed and voltage of inverter .normally this setting range and factory setting will…
motor system
motor system in inverter MOTOR 2 LINE TO LINE RESISTANCE . To set the motor,s line to line resistance in unit of ohm . note: the factory setting depends on…
WINNER,S OPERATION SELECTION AT OVER SPEED
OPERATION SELECTION AT OVER SPEED/ DEVIATION . winner inverter set the stop method when over speed occurs.0:deceleration to stop using deceleration time 1 (c 1-0 2). 1: coast to stop.…
inverter speed value
inverter speed value . Enable /disable integral value during ace/decal , 0: disable (the integral function is not used while accelerating or decelerating : it is used at constant speed).…
digital systems
DIGITAL SYSTEMS INPUT OPTION OF INVERTER. To set the input method of digital command card . 0: bcd . 1% 1: bcdo . 1% 2: bcdo. 01% unit 3: bcd…
3 phase inverter
3 PHASE INVERTER OUTPUT MODE SELECTION . Set the 3 phase inverter output mode in the following constants when using a d0-08 digital output card 0: – channel individual outputs…