440 VOLT INVERTER,S TERMINALS TABLE No Name Description Setting range Factory setting Change During Option Control methods v/f v/f with pg Open loop vector Flux vector H4-03 Bias (terminal 21) To set the voltage level deviation of multi function analog value output 1 and make the output characteristic to be parallel to the value of … Read more
No Name description Setting range Factory setting Change during operation Control methods v/f v/f with pg Open loop vector Flux vector H4-07 Analog output signal level selection The set signal output level of multi function analog value 1.2 (terminal 21,23)0:0~+10v 1:0~+_10v output note of setting : this signal level setting is suitable for multi … Read more
440 VOLT WINNER INVERTER,S MOTOR PROTECTION TABLE No Name Description Setting range Factory setting Change during operation Control methods v/f v/f with pg Open loop vector Flux vector L1-01 Motor protection selection Sets whether the motor overload function is enabled or disabled at electric thermal overload relay 0: disabled 1:enabled Note : this setting … Read more
Safety instructions Alert: This chapter includes important protection and working instructions. Check and protect this manual for the maintenance of the function. 1. Before using the unit, studying all the instructions and precautions on the manual batteries and all appropriate section. 2. Carefully – To restrict the risk of injury, completely positioned in a position … Read more
power inverter,s stall functions stall prevention selection during running. stall prevention function selection during operation. 0 : non effective . 1 : effective deceleration time 1. 2 : effective deceleration time 2. when setting 1 or 2 enabled is selected deceleration is started if the current of the stall prevention level during operation continues for … Read more
torque detection selection 1. to set the torque detection function 0:overtorque detection disabled.1:detection during speed gree only/ operation continuos after detection (minor fault) 2:detection during run /operation continuous after detection (minor fault) 3:etection during speed only/inverter output is shut off after detection(fault) 4:detection during run/inverter output is shut off after detection (fault) torque detection level … Read more
forward torque limit set the torque limit values as a percentage of the motor rated torque.four indevidual regions can be set. reverse torque limit note: torque limits can be set seperately for the 4 ways that torque can be applied: forward torque,reverse torque,forwards generative torque,and reverse generative torque. forward regenerative torque limit show the relationship … Read more
monitor selection after power up when the inverter is started please set the item need to display 1: frequency command 2: frequency command. 3: output current 4:the displayed item set by 01 _ o1. when inverter is started, the display the frequency command in the data displaying part (when factory setting is available) when the … Read more
user constant initial value this constant is used to record or clear the user constant defaults . 0: no change .(keep current setting.) 1: record user defaults .( record the current constant setting as user defaults.) 2: clear user defaults. ( clear the recorded user defaults.) note: this constant is used to record or clear … Read more
exception analysis when the inverter is at fault, the operator will have the exception display and output the action of fault contact. at the same time, the inverter’s output will be cut and the motor will coast to stop.(the stop method will decide by the set stop method if the spot method has been selected.) … Read more