OPERATION SELECTION AT OVER SPEED/ DEVIATION . winner inverter set the stop method when over speed occurs.0:deceleration to stop using deceleration time 1 (c 1-0 2). 1: coast to stop. 2: emergency stops using the emergency stop time ( c 1-0 9). 3:continue operation it dose not need to be set normally to protect the … Read more
inverter speed value . Enable /disable integral value during ace/decal , 0: disable (the integral function is not used while accelerating or decelerating : it is used at constant speed). 1: enabled (the integral function is used at all times), note: when v/f control with pg feedback is used integral control during acceleration and deceleration … Read more
3 PHASE INVERTER OUTPUT MODE SELECTION . Set the 3 phase inverter output mode in the following constants when using a d0-08 digital output card 0: – channel individual outputs code output ( binary system code) . note: the item output by d0-08 according to f6-01 setting , please set the code output as follows. … Read more
Win- va /vc,s deceleration / acceleration time has 4 options , to switch between these time option , please set deceleration / acceleration time option 1 ,2 at multi function input . setting value 7 = acceleration / deceleration time selection 1 . setting value 1 a = acceleration / deceleration time selection 2 . … Read more
When terminal 14 is used as frequency command please h3-09 (frequency command (current ) terminal 14 function selection ) to be if otherwise if you use this function fault (o p e 03) will occur . when h3 -09 (frequency command ( current ) terminal 14 function selection ) is set as if but multi … Read more
It is the function to control the inverter,s output frequency through the control terminal,s on/off . when using this function please make sure to set the 2 multi function input up/down command .if only to set single multi function input the fault ope 03 will occur .besides in the occasion where acceleration /deceleration stop was … Read more
In the occasion where up/down was set multi step peed command 1~8 will be all non effective . the dwell output frequency when up/down is on will be memorized by the value of d4-01 (dwelling function option of frequency command) the setting value is 1 . the value will be recorded after the power is … Read more